48"x21" section of 18mm thick plush (softer) foam undermat. This our...
48"x21" section of 9mm thick plush (softer) foam undermat. This our...
DASA RACING VALVE CAPS Sold by unit
HEAD GASKET YAM 1200R
FLYWHEEL ORING YAM 1200 99/00
HEAD GASKET YAM 1200
FLYWHEEL COVER GASKET YAM 1100/1200
BASE GASKET YAM 1200
EXHAUST GASKET YAM GP 800
BASE GASKET GP800 SOLD BY UNIT (2 REQUIRED)
HEAD GASKET YAM 800 GP
All parts from RRP / Rick Roy Products.
RRP SUPER LITE ADJUSTABLE HANDLE POLE for RICKTER, KAWASAKI, YAMAHA and OCTANE. Available in Black with silver tubes, Silver with silver tubes, Red with Black tubes, Blue with black tubes and Green with Black tubes.
When you install a RRP 2 hole air inlet bracket and want to run the OEM handle pole spring you must use this part to create the proper tension and handle pole weight. This part only fits the RRP handle pole brackets.
Will allow you to install the dual air intake of 2 1/2 inches each That will double you air intake resulting in more power. Less water will enter into you engine compartment due to the fact that it will be breathe by the highest point on the ski. This bracket is lower than stock for lowering the pivot point on the ski to Improve the handling.
Helps to increase performance and to gain more height for aerial maneuvers. It allows for full functionality of the steering nozzle and trim system. • Prevents the water flow from the outside of the pump entering between the restriction and steering nozzles, breaking the flow water inside the pump. • Prevents back spray when turning the steering nozzle,...
Rickters top of the line foot hold.These foot holds are a direct bolt onto any RRP foot hold plate. The ninja foot holds fit all Rickter models and come standard with the XFS Ninja edition. These are for serious riders looking for that extra edge, they are dramatically improved compared to standard foot holds.
This newly developed and proven RRP design moves the load on your steering cable from the threaded part of the cable to the main smooth part of your steering cable where it has more strength. RRP recommend you put these on both the pump end and the steering end of the cable for maximum protection 5MM FOR OEM SJ CABLE 6MM FOR BLOWSION, SKAT TRAK, OEM CABLE