48"x21" section of 18mm thick plush (softer) foam undermat. This our...
48"x21" section of 9mm thick plush (softer) foam undermat. This our...
DASA RACING VALVE CAPS Sold by unit
HEAD GASKET YAM 1200R
FLYWHEEL ORING YAM 1200 99/00
HEAD GASKET YAM 1200
FLYWHEEL COVER GASKET YAM 1100/1200
BASE GASKET YAM 1200
EXHAUST GASKET YAM GP 800
BASE GASKET GP800 SOLD BY UNIT (2 REQUIRED)
HEAD GASKET YAM 800 GP
Complete exhaust for your ski and all parts for them.
The ATP designed and manufactured aluminium Waterbox offers a impressive increase in power and throttle response over the OEM Waterbox, it even offers a good power gain over the previous best known & selling Waterbox.Designed to optimize space and be a simple & perfect fit in the SuperJet hull. Exhaust noise is louder & deeper than stock...
Flow Control Valve - 3/8" Adjustable Pro Model. This Jetworks 3/8" valve has been designed to prevent water flow to the waterbox at idle and off idle engine speeds. This allows the craft to be more responsive off the line and around turns. Results are HUGE gains in throttle response. All stainless internal parts. IJSBA race legal.
The Flow Control Valve provides improved throttle response and much quicker starts by drying out your waterbox at low rpm and idle speeds. Tests have shown an average acceleration improvement of 10 feet over a non-equipped model in the first 50 feet. Adjusted by shims.
Pro-Tec exhaust pipe mount rubber damper washer. This item is used on all Pro-Tec cast aluminum expansion chambers. Please note that each Pro-Tec pipe mount will require (1) 12-2412 pipe mount insert and (1) 12-2414 pipe mount washer. Over the years Pro-Tec has made the cast aluminum pipes in 2, 3 and 4 mount versions.
Pro-Tec exhaust pipe mount rubber insert. This item is used on all Pro-Tec cast aluminum expansion chambers. Please note that each pipe mount for the Pro-Tec cast aluminum pipes requires (1) 12-2412 pipe mount insert and (1) 12-2414 pipe mount washer. Over the years Pro-Tec cast aluminum pipes have been made in 2, 3 and 4 mount versions.
Here is the SXR version of our popular ATP designed and manufactured aluminium Waterbox. This not only offers an impressive increase in power and throttle response due to it's ability to evacuate the water so efficiently, it also holds alot less water than the OEM SXR waterbox due to the smaller volume.
Use this composite drop in baffle insert to cover the area removed during install of the Factory Dry Pipe. This is the same insert used by the Factory Kawasaki Race Team in 2003. Each baffle comes with extra air drop tube, install flange and epoxy glue to move and replace the one displaced by the pipe install.
Power Factor Yamaha freestyle exhaust system with Power Box. This is the ultimate freestlye exhaust system. Designed for flat water free stlye, and free ride. The PFP exhaust sytems optimizes the power band of most modified Jet Ski Engines. The exhaust manifold bolts driectly to any Yamaha 701 exhaust bolt pattern
This Heavy Duty Rear Exhaust Hose replaces the expensive and prone to fail OEM Hose. Constructed of braided 4 ply polyester hose, Mamba virtually eliminates collapsing and overheat issues associated with the OEM hose. Mamba's flexible construction makes it the preferred choice for all aftermarket hull and motor installs due to its ability to contour...